【Texture】
The quality is fine.
It is a matter of Bolt strength rather than Slider strength.
If it falls over, it will probably bend.
[Usage.
Falling on one's feet・・・・◎ Minor injury
Public road・・・・・・◯ Good to know.
Circuit... Fat. Good to know.
Lawn, Gu Label・△ Extra resistance will occur.
In general, I don't think there are any negative effects from the installation.
(The above comment is an estimate.)
Installation procedure
Tools will be noted in the comments.
You can do it yourself, but do one side at a time.
The tightening Torque is 62 and there Torque.
Equipment of Guardetc.
DAYTONASlider (this product)
Engine Guard (y'sGEAROEMOption)
Rear stand hook (with separate imprint)
These are the three items above.
The bar end mirror is verified by removing it from the beginning because it is fatal to contact.
Results of the fall experiment
First, basic knowledge.
When the Motorcycle collapses, it is always in contact with the ground at some three points on the body. (Three points of ground contact stabilizes it.)
Tire (front wheel)
Tire (rear wheel)
Handlebar End
footpeg
SIDE STAND
Tandem Footpeg
Brake pedal、Shift Pedal
STAND
Crankcase (Engine GuardRight)
Generator cover (Engine GuardLeft)
Slider (this product)
etc., at least three of these points are always in contact with the ground.
The final stable ground is made at the Handlebar End, Slider, and Rear stand hook, but there are places where contact is made before reaching that point.
[For Left Side
Shift Pedal, Side Stand, and footpeg are almost simultaneous.
Tire floats quickly.
?Engine Guard
?Slider
Rear stand hook, Rear footpeg depending on angle
?Handlebar End
[On the Right Side
?Brake pedal and footpeg at about the same time.
Tire floats quickly.
?Engine Guard
?Slider
Rear stand hook, Rear footpeg depending on angle
?Handlebar End
【Review】
In either case, it will not hit the Tank unless something breaks or bends to Large width.
Also, there is an Engine Guard, so there is little chance of the vehicle becoming disabled.
Even if there is no engine guard, the crankcase and generator cover are unlikely to be damaged because the slider always enters at the three stabilization points. (The Crankcase and Generator cover will be scratched because they will make contact once before the three stabilization points including the Slider).
Assumption of inability to run
Handlebar breakage
footpeg fold
Fracture from the base of the Lever
Driver Injuries
【Cospa】
It doesn't have to be DAYTONA, but if you put it on, the cosmetics are enough to get you home even if you fall down.
I enjoy both Gymkhana and Circuit somewhat, so I thought about a sturdy Engine Guard (SSBetc.), but until my first fall, I thought I would try this Slider for appearance.
[Others]
For those who are concerned about the length of Slider.
If the Slider is too long, it will tip over to the Tank side (upper side of the Motorcycle) using it as a fulcrum.
It is a mistake to think that if it is long enough, no other contact will be made.
Fits: KAWASAKI ZRX1200S 04, KAWASAKI ZRX1200S 03, KAWASAKI ZRX1200S 02, KAWASAKI ZRX1200S 01, KAWASAKI ZRX1200R 08
Like all Daytona products, packaged securely and includes clear instructions (in Japanese) with pictures. Would've been helpful to have a little more info about where to jack the engine to support it during bolt removal, but you can figure it out. Hope I never have to use them, but I'm glad to have them!View Detail
Fits: KAWASAKI ZRX1200S 04, KAWASAKI ZRX1200S 03, KAWASAKI ZRX1200S 02, KAWASAKI ZRX1200S 01, KAWASAKI ZRX1200R 08
I ordered these for my ZRX1200 for track use, they were easy to fit and appear to be well made. I have not tested them yet and hope i never do. Arrived in the uk within a week. View Detail
Fits: KAWASAKI ZRX1200S 04, KAWASAKI ZRX1200S 03, KAWASAKI ZRX1200S 02, KAWASAKI ZRX1200S 01, KAWASAKI ZRX1200R 08
Installed in case of emergency. The effect is not known as it has not rolled yet. The installation was done by an amateur, Quantity:Pair (for Left and Right) and about 15 minutes. It is a very easy process. Please use it as a good luck charm.View Detail
Fits: KAWASAKI ZRX1200S 04, KAWASAKI ZRX1200S 03, KAWASAKI ZRX1200S 02, KAWASAKI ZRX1200S 01, KAWASAKI ZRX1200R 08
Turn off the Handlebar full Left, starting the engine stall At the same time, we moss. The damage was Clutch lever, Mirror, Grab Bar, both at the tip slightly gully scratches. The moment they broke, Bikini cowl, Blinker, Starter coveretc. , I thought it was saddest! I thought it was saddley, but I became completely blue, but at the beginning I could not believe it at first, I checked it all out but the others were Large durable. At the same time as purchasing Motorcycle it was Large Correct answer with Slider. From now on, if you take care of SliderView Detail
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING