calibre : φ26
Pitch do carburador : Single Body
[Partes incluídas]
Isolador
Manifold
Junta
[partes recomendadas separadamente]
Parafuso de ajuste grande
Conjunto Universal de Tanques de Captura de Petróleo
[Peças separadas necessárias para instalação]
Conjunto de acelerador (para TM-MJN22/24/26) (Deve ser instalado com o mesmo encaminhamento que o fio de acelerador STD). )
Qualquer um dos seguintes limpadores de ar
Funil original Yoshimura para TM-MJN22/24/26
・DUAL STACK FUNNEL SYSTEM SET for TM-MJN24/TM-MJN26
Filtro de ar K&N (POWER FILTER)
*Como a folga entre a parte inferior do carburador e o motor pode não ser fixada dependendo da especificação do veículo, é necessário fixar a folga adicionando um espaçador angular (vendido separadamente). .
*Se este produto for instalado num veículo equipado com o Cyclone Tipo 7 (MONSTER TAIL) para Macaco, o silenciador e o carburador interferirão um com o outro. Por favor, utilizar o espaçador angular (vendido separadamente) para mudar o carburador da mão direita para a mão esquerda.
*Pode escolher entre os dois tipos seguintes, de acordo com a especificação do seu motor. Os acessórios são os mesmos, mas o cenário é diferente. Este produto é apenas para uso em corridas.
Intake Diameter:φ26
Carburetor Pitch :Single Body
[Included parts]
・Insulator
・Manifold
・Gasket
[Separately recommended parts]
・Large Adjusting Screw
・Universal Oil Catch Tank Set
[Separately required parts for installation]
・Throttle Set (for TM-MJN22/24/26) (Must be installed with the same routing as stock throttle wire.)
Any of the following air cleaners
・Yoshimura original funnel for TM-MJN22/24/26
・DUAL STACK FUNNEL SYSTEM SET for TM-MJN24/TM-MJN26
・K&N air filter (POWER FILTER)
*Since the clearance between the lower part of the carburetor and the engine may not be secured depending on the specification of the vehicle, it is necessary to secure the clearance by adding angle spacers (sold separately)...
*If you install this product on a vehicle equipped with Cyclone Type 7 (MONSTER TAIL) for MONKEY, the exhaust and carburetor will interfere with each other.Use the angle spacer (sold separately) to change the right hand carburetor to a left hand one.
*You can choose from the following two types according to the specification of your engine.The accessories are the same, but the setting is different. This product is for racing use only.