Encaixa:- HONDA LEAD50
- HONDA LEAD 90
- HONDA SPACY100
- HONDA SPACY125
- HONDA TACTSeries
- ...e mais.
Because the rubber at the bottom of the cover is solid, you can use the Tire when you put it on I think it's good that you can squeezed in until the end!But on the other hand, when you remove the cove...consulte Mais informação
Encaixa:- YAMAHA GEAR (GEAR) 4KN [Genuine part number] 3HK-14613-00
- HONDA Monkey (MONKEY) AB27 [Genuine part number] 18291-GE2-920
- HONDA SUPER CUB 50 (SUPER CUB) C50 [Genuine part number] 18291-001-010
- HONDA Monkey (MONKEY) AB27 [Genuine part number] 18291-HB2-900
- HONDA SUPER CUB C125 JA48 [Genuine part number] 18291-GE2-920
- ...e mais.
It is cheaper than OEM parts and the quality is the same as OEM partsWhen the exhaust system and engine are removed or installed along with the all-pen work, the exhaust system and the engine are remo...consulte Mais informação
Encaixa:- HONDA MAGNA
- HONDA SUPERDio ZX
- HONDA MOTOCOMPO
- HONDA CUB type/LITTLE CUB
- SUZUKI VERDE
- ...e mais.
Purchased to prevent direct absorption of rain and snowIn GYROx, the direction of travel is reversedmaybe making a board between carburetor and air cleaner would be even better?(When Cover is removed....consulte Mais informação
I installed it on my APE 100Other Companies' Quantity:It is available in a single item with a finer count than most of the set products that are marked to #5 I used #78 because the OEM #72 was lighter...consulte Mais informação
Encaixa:- HONDA CBX125 92 JC11 F [Frame No.] JC11-1200001 to 1202464 [Point of use] rear
- HONDA CHALY 70 82 CF70 [Frame No.] CF70-3000029 or later [Point of use] Used for front & rear (Simultaneous exchange:2 sets used)
- HONDA SUPER CUB 50 08 AA01 [Frame No.] AA 01 - 1700001 or later [Point of use] Used for front & rear (Simultaneous exchange:2 sets used)
- HONDA CBX125 84 JC12 C [Frame No.] JC12-1000001 to 1005741 [Point of use] rear
- HONDA SUPER CUB 50 07 AA01 [Frame No.] AA01 [Point of use] Used for front & rear (Simultaneous exchange:2 sets used)
- ...e mais.
I installed it in APE 100 I bought it from the place where I bought it and replaced both Front and RearThe OEMs were Mild all the way through, but the Pro Brake Shoe, especially in the early stages, h...consulte Mais informação
Encaixa:- HONDA LEAD50
- HONDA LEAD 90
- HONDA SPACY100
- HONDA SPACY125
- HONDA TACTSeries
- ...e mais.
I bought this for my first motorcycleIf I had to choose, I would say that the windbreaker at the bottom of the Cover is a bit too short It isThere is plenty of room in the Size, and if you are wearing...consulte Mais informação
I've been using Lithium batteries for 4 yearsThe following is a description of the differences between this battery and a normal lead batteryOrdinary lead-based batteries are more resistant to voltage...consulte Mais informação
I used it on my CBR1000RR (SC59)I replaced it 3 years ago and it still runs the Cell fineWeight is less than half of YTZ7S of OEM and Size is also SmallI could feel the lightness of the bike when I ro...consulte Mais informação
Encaixa:- SUZUKI DR-Z400 S 02 [SK43A] ■ Rear:1 set used
- SUZUKI 250SB 04 [LX250L] [Frame No.] LX250L-A01001 or later ■ Rear:1 set used
- SUZUKI DR-Z400 S 03 [SK43A] [Frame No.] SK43A-101483 or later ■ Rear:1 set used
- SUZUKI DR-Z400 S 01 [SK43A] [Frame No.] SK43A-100811 or later ■ Rear:1 set used
- SUZUKI 250SB 03 [LX250L] [Frame No.] LX250L - A00001 or later ■ Rear:1 set used
- ...e mais.
i installed it on my xlr250 baja's rear, but it was too thick to fit, so I forced it to fit I left the Brake limping in the Red, and after 50k miles or so, I felt good about it I had no problem with t...consulte Mais informação
Encaixa:- HONDA CBX125 92 JC11 F [Frame No.] JC11-1200001 to 1202464 [Point of use] rear
- HONDA CHALY 70 82 CF70 [Frame No.] CF70-3000029 or later [Point of use] Used for front & rear (Simultaneous exchange:2 sets used)
- HONDA SUPER CUB 50 08 AA01 [Frame No.] AA 01 - 1700001 or later [Point of use] Used for front & rear (Simultaneous exchange:2 sets used)
- HONDA CBX125 84 JC12 C [Frame No.] JC12-1000001 to 1005741 [Point of use] rear
- HONDA SUPER CUB 50 07 AA01 [Frame No.] AA01 [Point of use] Used for front & rear (Simultaneous exchange:2 sets used)
- ...e mais.
I've been using this product for a few years now and it's very nice, it's got good stopping power, it's got life Is it normal? I think it's better than a certain Manufacturer's productI always have Qu...consulte Mais informação
Encaixa:- SUZUKI VECSTAR150 99 [Frame No.] CG42A-105020 or later
- SUZUKI VECSTAR125 95 CF42A [Frame No.] CF42A-110517 or later
- SUZUKI Intruder Classic400 04 VK54A [Frame No.] VK 54 A - 101458 or later
- SUZUKI VECSTAR150 98 [Frame No.] CG 42 A - 103625 or later
- SUZUKI VECSTAR150 97 [Frame No.] CG 42 A - 102296 or later
- ...e mais.
I replaced a 2006 K7 OEM BreederValve with a fluid blotch in the OEM BreederValveIt is made of stainless steel and looks greatI don't know if seal tape is necessary, but just in caseconsulte Mais informação
Encaixa:- YAMAHA TRACY150 CZ150R 87
- YAMAHA CYGNUS 150 92
- YAMAHA CYGNUS 88
- YAMAHA Axis Z 18
- YAMAHA Axis Z 19
- ...e mais.
New Address 125 OEMRear tireDoes it feel like you can touch it with your fingers, or can you expect Grip? So I attacked the Curve a bit, and it didn't stand up at all!If you bank it to a certain exten...consulte Mais informação
Encaixa:- YAMAHA YB-1
- YAMAHA TZR50 R
- YAMAHA TZM50 R
- YAMAHA TY250Z SCOTISH
- YAMAHA SEROW225 (Rear drum car)
- ...e mais.
The original Valve on the AXIS 90 was too dark and very dangerous to drive at nightI was looking for a Valve that would brighten things up a bit, and this is what I foundIt definitely makes it brighte...consulte Mais informação
Battery deteriorationAXIS 90 is a transversal type battery, so I have some resistance to the liquid type, and I'm not sure about the Gel typeI am a holiday rider and the frequency of riding is about o...consulte Mais informação
It's really easy, and that's as good as it gets, DAYTONA!I was always trying to decide which one to buy, but I ended up choosing Daytona's for the high street and it was the right choice! Thank you fo...consulte Mais informação
Encaixa:- HONDA TACT
- HONDA LEAD 90
- HONDA Sh MODE
- HONDA JULIO
- HONDA LEAD125
- ...e mais.
When I removed the OEMExhaust System, for some reason I couldn't find the Gasket! (How is that possible?) At any rate, I put this Gasket in and replaced the Exhaust System There is no exhaust leak at...consulte Mais informação
I put it on SEROW225 W. But the way of turning Cell is very weak when I engine in the mountain I charged the battery every time I went out, but the Cell did not change When I returned to normal Batte...consulte Mais informação
I changed it after I started riding the CRF250L For now, there are no problems so farI think it has lasted for about 3 years, and because it is half the size of the OEM's, you can add a spareconsulte Mais informação
Encaixa:- PIAGGIO RUNNER 125200VXR
- KYMCO XCITING250
- SUZUKI ADDRESSV100
- YAMAHA CYGNUS X SR
- YAMAHA Axis Treat
- ...e mais.
After a year or so, Waterproof gets weaker, but if you consider the price, I'm happy enough3 stars for usability because the strap under the car body is hard to tie, and it doesn't touch the ground af...consulte Mais informação
Encaixa:- HONDA LEAD 90
- HONDA BROAD 90
- HONDA JOKER90
- HONDA CABINA 90
I changed the weight roller to various settings, but I'm not satisfied with it When I contacted KN Planning, I found out that the groove on the Torque Camshaft is not the same as the OEM groove I trie...consulte Mais informação














?
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING